The MVP 20W is the newest in compact Variable Voltage and Wattage box mods. It has advanced safety features, a long lasting 2600mAh battery, ‘Vape while you charge’ technology and also acts as a charger for your mobile phone and other electronic devices.
Note: Atomizer not included. It is in the photos to demonstrate the size and look of the device.
Features of The MVP 20W
Voltage can be adjusted from 3.3 – 7.5 volts in .1 volt increments.
Wattage can be adjusted from 6.0 – 20.0 Watts in .5 watts increments.
Battery Level Indicator:
The MVP20W battery capacity is displayed via green, yellow and red LED.
Green = Almost fully Charged. When the MVP20W fully recharged the LED light will power off.
Yellow = Half Power.
Red = Low Power. Charge the MVP20W.
Large battery capacity:
The MVP20W has a built-in 2600 mAh polymer Li-Ion rechargeable battery.
ON/OFF battery switch:
Press the power button three times in rapid succession to turn on the MVP20W. When the MVP20W is powered on Hold down the button to activate the atomizer and vape. When the MVP20W is not in use, press the button three times in succession to power off the MVP20W Advanced Personal Vaporizer. Always power off the MVP20W Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse.
Reads the resistance of your atomizer/cartomizer/clearomizer.
The integrated Puff counter will record the number of puffs you have taken. Either press “P “button or “U” button for 1 second to check the number of puffs. The Puff Counter will reset to 0 whenever the device is powered off.
10 second Cutoff
If the activation button is held for longer than 10 seconds the MVP20W Advanced Personal Vaporizer will stop firing until the button is released and pressed again.
Low Voltage Warning
The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the MVP20W Advanced Personal Vaporizer will power off automatically.
Short Circuit/Atomizer Protection
Short Circuit/Atomizer Protection protects the MVP20W Advanced Personal Vaporizer against shorted atomizers and will stop the unit from functioning in unsafe conditions.
The MVP20W Advanced Personal Vaporizer monitors the battery voltage and will automatically power off when the battery is discharged.
‘Vape while charging’ Technology
The MVP20W is recharged with a Micro USB cable. When plugged into a power source the MVP20W can also be vaped and charged at the same time with Innokin Technology’s ‘Vape while you charge’ pass-through technology.
Remembers last Voltage or Wattage setting
When the MVP20W is turned off it will store the current voltage or wattage setting and it will retain the setting when the MVP20W is powered on.
Built-in 3 digit display
Digital display shows the Ohms meter, Voltage / Wattage setting and the number of Puffs taken since last time the battery was turned off.
Portable power source for electronic products
To charge your portable electronic device with the MVP20W – set the small pin switch on the bottom of the MVP20W to the ON position and connect a microUSB cable to the USB OUTPUT port (DC 5V, maximum output current 0.5A)To maximize the battery charge of your MVP20W please ensure that the bottom switch is set to the Off position when you are not using the portable charger function.
Operating Voltage: 3.3V-7.5 V
Operating Wattage: 6.0W-.20W
Standby current: 100uA max
Maximum output Wattage: 20W
Maximum output Current：6A
Maximum output Voltage: 7.5V
Clearomizer Resistance: 1.0 Ohm (minimum)
Battery: Built-in 2600 mAh polymer Li-Ion rechargeable battery.
Charging: Micro USB DC5V/1000mA
OUTPUT port ：DC5V /1000mA
- DetailsIf you’re looking for a heavy duty variable wattage mod then the Itaste 134 is definitely for you. This thing not only looks amazing it also packs a powerful and adjustable vape.The iTaste 134 is a microprocessor-controlled VW mod that allows you easily adjust the wattage with a rotational wheel. The solid stainless steel body gives it a fairly hefty weight. With 510/eGo threading, and a removable beauty ring, this mod will compatible with virtually any clearomizer, cartomizer or tank.
- Power On/Off: press the firing button quickly 3 times
- Adjusted with the rotational wheel to 6.5W, 7W, 8W, 9W, 10W, 11W, 12W, and 12.5W
- Battery power indicator: (green = fully power; yellow = medium power; red = low power)
- 10-Seconds cutoff
- Short circuit protection
- Reverse battery protection circuit
- Low voltage warning
- LED light blinking mode
- Removable beauty ring
- 510/eGo threading connector
- Can be powered by 18650 battery (battery sold separately)
- Comes with a iClear30 dual coil clearomizer (with rotatable drip tip)
The Innokin Itaste iTaste VTR is a solid, sleek and heavy duty variable wattage/voltage vaping device with a detailed look that gets people asking about it. It has a rotation wheel and a protective skeleton to hold the tank inside partially within the device. The voltage and wattage can be adjusted with the rotational wheel while the screen displays voltage or wattage. The VTR offers various controls over settings allowing to tune it to a more accurate performance.
1 x Innokin iTaste VTR
1 x iClear 30S Tank (with rotatable tip)
1 x Gun Metal 510 Extension with Beauty Ring
1 x Metal Case
1 x User Manual
Variable Voltage: 3.0 – 6.0 volts
Variable Wattage: 3.0 – 15.0 W
Short Circuit Protection;
RMS (root mean square);
Reverse Battery Protection Circuit;
Resistive Load Detection (Ohms meter);
ON/OFF battery switch;
LED Battery Power Display;
Low Voltage Warning;
Overtime Vaping Warning (10 second switch cutoff);
Battery safety protection (Vent holes);
High compatibility 510/eGo connector: Built-in 3 digit display (Ohms meter, Volts /Watts, Atomizer voltage output)
Replaceable Battery: iTaste VTR supports 18650 batteries (unprotected)
The Itaste SVD is a top of the line Mod Starter Kit. With Variable voltage ranging from 3.3-6.0 volts you will be able to find the perfect setting for the way YOU want to vape. The iTaste SVD has a great look and amazing stainless steel finish. The built in 3 digit display lets you know what voltage you’re vaping at and if you are vaping too long.
- Variable Voltage: voltage can be adjusted from 3.3 – 6.0 volts in .1 volt increments.
- Variable Wattage: Wattage can be adjusted from 3.0 – 15.0 W in .5 watts increments.
- Short Circuit Protection.
- Reverse Battery Protection Circuit
- Battery Voltage Detection
- Resistive Load Detection ( Ohms meter )
- ON/OFF battery switch
- LED Battery Power Display
- Low Voltage Warning
- Overtime Vaping Warning
- Telescopic Tube supports 18350, 18500 or 18650 batteries
- Battery safety protection
- Myriad compatible ( Thread fit iClear10 ,iClear16, iClear30,CE4,CE5 ,eGo, T2,T3 , VIVI NOVA and 510 etc )
- Change battery and switch VV or VW have parameter memory function
- Built-in 3 digit display ( Ohms meter , Volts /Watts , Atomizer voltage output )
- Comes with the newest iClear30 atomizers with cozy rotatable drip tip
Note: Batteries not included
iTaste VV Variable Voltage Vaporizer Pen with elegant Euro Design has sleak streamlined look & feel…No question it would be the vaporizer of choice for a Runway Model in Milan!! Here come the stats…510 threading & Super Cool puff counter allow you to keep track of your intake along with variable voltage from 3.3-5.0 volts in .1 volt increments, and variable wattage from 6.0-11.0 W in .5 watts increments, 800 MAH energy, Ohms meter, LED battery indicator, Myrad compatible, on/off switch/
What you get:
Itaste VV pen
Box and Manual
Note: The iClear30 systems are only in stock. They will come with one large iClear30 instead of 2 iclear 16's.
iTaste MVP 2.0 Personal Vaporizer with its clever design allows the nicotine consumer to “Vape” e-fluids in a variety of flavors and milligrams of nicotine in a variable voltage environment…Also can double as a charger for most popular electronics, phones, tablets, etc…Attributes include -puffer accouter, polymer li-ion rechargeable battery, long live energy 2600mAh, battery capacity display, On/Off safty switch, passthrough, standard micro & 2.0 USB socket, short circuit/atomizer protection, over-discharge protection
- Designed with detachable atomizer
- Micro USB socket for charge iTaste MVP
- USB 2.0 output socket, as a mobile power supply for external devices
- The LED lights will show green, yellow or red to indicate whether there is full battery life, half capacity or charging needed
- Voltage can be adjusted from 3.3-5.0 volts
- The three most popular power connectors for iphone/iPods, mini USB (Motorola/Blacberry), a Micro USB(Motorola/Nokia/LG/Samsung)
- Suitable for 510, RN4081, 901, 8105, Tidy etc, atomizer